Reely HT-6 - Page 57

57
Setting the delta mixer:
• Switchonthetransmitterandcallthefunctionsettingmenu.
• Movethecursorarrowtothemenuitem„Elevon“withthetwo
buttons „UP“ and „DOWN“.
• Brieypushthebutton„OK“toactivatethemenuitem.
The display shows the mixer indication with pre-set values.
• Pushing the buttons „UP“ or „DOWN“ can activate „On“ or
deactivate „Off“ the mixer.
• Whenpushingthebutton„OK“,thecursorarrowwilljumpto
the defection values for the aileron function (CH1).
• Alternatinglydeecttheencoderfortheaileronfunctiononthe
onesidetothestopandadjustthedesireddeectionvalues
of both servos by pushing the buttons „UP“ or „DOWN“. When
setting a negative value, the running directions of the two ser-
vos will reverse. If the button „OK“ is pushed and held, the
factory parameters are called.
• When pushing the button „OK“ briey again, thecursor ar-
row will jump to the defection values for the elevator function
(CH2).
• Alternatingly deect the encoder for the elevator function
downoruptothestopandadjustthedesireddeectionvalues
of both servos by pushing the buttons „UP“ or „DOWN“. If the
button „OK“ is pushed and held, the factory parameters are
called.
• Keepthebutton„CANCEL“pushedforalongerperiodtosave
the settings. The display then shows the function setup menu
again.
• Pushthebutton „CANCEL“repeatedlyuntilyou getbackto
the operating display.
If one of the two servos runs in the wrong direction,
you can use the reverse setting (see chapter 14. a) to
change the running direction of the servo.
Figure 49