RFL Electronics RFL 9660 - B - Call Request; C - Call out; D - Password

b - Call Request
The "b" selection lets you specify the call request method. This controls how the
port device request lines will request connection to the RFL 9660.
Format: PORT n> B [ENTER]
The following prompt will appear on your display:
0 None
1 RTS+DTR
2 DTR+RTS
3 RTS
4 DTR
Enter Mode (0 - 4): _
Select the method you want, enter the number next to it, and then press the [ENTER]
key.
c - Call Out
This selection lets you control whether the DTE connected to the port can call out
through the RFL 9660.
Format: PORT n> C [ENTER]
The following prompt will appear on your display:
Request Enable (Y/N) _
Press the [Y] key for "yes" or the [N] key for "no," and then press the [ENTER] key.
d - Password
This selection lets you enter or change the password assigned to the port. The port
password is a character string that must be entered before a user is allowed to
access a device port. If a password has been set for a device port, users will be
asked to enter the password each time they try to access a port; they will not be
granted access unless they enter the password correctly.
Format: PORT n> D [ENTER]
The following prompt will appear on your display:
Enter new password: _
Enter the desired password, which can contain up to seven characters.
NOTE
Port passwords are case-sensitive. Once you enter a port password, all users must enter it the
same way you did; otherwise, the RFL 9660 will not accept it.
RFL 9660 RFL Electronics Inc.
August 18, 1998 5-6 (973) 334-3100