RFL Electronics RFL 9660 - Typical General Access Command List Display

Esc -Abort command
H -Help
D -Run diagnostics
I -Port Information
Q -Quit session
Port #/Label -Port selection
REMOTE> _
Figure 4-21. Typical general access command list display
11. If you are receiving "REMOTE>" prompts and you know the port number or label for the device you
want to connect to, enter it and then press the [ENTER] key. The RFL 9660 will connect you to that
device.
NOTE
If a port password has been stored for that port, you will have to enter it before the RFL 9660 will grant
you access. Remember that passwords are case-sensitive. If the password was entered as all
CAPITALS, you will have to enter it that way for the RFL 9660 to accept it.
12. If you do not know the port number or label for the device you want to connect to, you can view a list of
the RFL 9660's device ports by pressing the [I] and [ENTER] keys.
A list of devices connected to the RFL 9660 will appear on your display, with the
"REMOTE>" prompt beneath it. (See Figure 4-22). Find the device you want on the list,
and enter its number or label next to the prompt.
RFL 9660 RFL Electronics Inc.
April 24, 2007 4-20 (973) 334-3100
(site ID)
# TYPE LABEL MODE DTR RTS CallBack
1 RS232 SEL 221F - Line 21 0 0 0 N
2 RS232 OPTIMHO - Line 15 0 0 0 N
3 RS232 DLP - Line 17 0 0 0 N
4 RS232 DFR 3 4 0 0 Y
5 RS232 QUANTUM 0 0 0 N
6 RS232 0 0 0 N
7 RS232 0 0 0 N
8 RS232 0 0 0 N
REMOTE> _
Figure 4-22. Typical port summary table