RFL Electronics RFL 9660 - 3.11 USING THE RFL 9660 AS A SUPER-USER

3.11 USING THE RFL 9660 AS A SUPER-USER
Once the basic switch and port configuration settings have been made, the RFL 9660 is ready for regular use.
There may be cases where some of the configuration settings will have to be changed to make the RFL 9660
compatible with the equipment in your substation or your telephone system. If you need to make additional
configuration setting changes, refer to Section 5 for more detailed information.
Once passwords are set up and enabled, people who access the RFL 9660 as regular users can only use the
general access commands described in Section 5 of this manual. They will not be able to use any of the super-
user commands, and will not be able to change any of the configuration settings.
NOTE
When you are finished using the RFL 9660, use the "Q" command to terminate the session and then
disconnect the terminal and cable from the RFL 9660's LOCAL connector.
RFL 9660 RFL Electronics Inc.
October 1, 1999 3-24 (973) 334-3100