RFL 9660 RFL Electronics Inc.
April 24, 2007 4-34 (973) 334-3100
4.9 CONNECTING THE LOCAL AND MODEM PORTS
The "MODEM" command only appears if your PC is connected to the RFL 9660's front-panel LOCAL connector.
It allows you to connect the local port to the modem port for calling out to another substation. This also allows
you to change the factory-set configuration of the RFL 9660's modem (for example, the number of rings before
auto-answer).
To connect the local and modem ports, type in the word "MODEM," and then press the [ENTER] key.
Format: LOCAL> MODEM [ENTER]
The following prompt will appear on your display:
Local port connected to Modem port!
To alter type (deselect code)
When you are finished dialing out, type in the deselect code ("BYE"). The RFL 9660 will hang up and disconnect
the local port from the modem port. While it is doing this, the following message appears on your display:
Please wait...
When the RFL 9660 is ready for normal operation again, your normal prompt will reappear.
To Next Page
Loading...