RFL 9660 RFL Electronics Inc.
August 18, 1998 5-10 (973) 334-3100
j - Local Port DTR
This selection lets you determine whether the DTR line will be monitored at the
LOCAL port.
Format: PORT n> J [ENTER]
The following prompt will appear on your display:
Monitor Local port DTR {Y/N} [Y]: _
As shown in the prompt, this can be set to "Y" or "N," with "Y" being the default
value. Once you have entered your choice, press the [ENTER] key.
k - Local Flow Control (XON/XOFF)
This selection lets you determine whether the LOCAL and MODEM ports will use
XON/XOFF flow control when communicating with this port.
Format: PORT n> K [ENTER]
The following prompt will appear on your display:
Enable XON/XOFF at Modem & Local [Y]: _
As shown in the prompt, this can be set to "Y" or "N," with "Y" being the default
value. Once you have entered your choice, press the [ENTER] key.
If you set the "k" selection to "N," the following prompt will appear on your display
above the list of selections if the 2400 baud modem ( Part No. 104445 ) is installed:
Do NOT operate Modem/Local ports above 2400 baud
If you set the "k" selection to "N," the following prompt will appear on your display
above the list of selections if the 14.4Kbps modem ( Part No. 104855 ) is installed:
Do NOT operate Modem/Local ports above 9600 baud
l - Port Flow Control
This selection lets you specify the flow control method for the port.
Format: PORT n> L [ENTER]
The following prompt will appear on your display:
0 None
1 RTS/CTS
2 DSR/DTR
3 XON/XOF
_
Select the method you want, enter the number next to it, and then press the
[ENTER] key.
To Next Page
Loading...