RFL Electronics RFL 9660 - V.92 Commands

RFL 9660 RFL Electronics Inc.
April 24, 2007 13-4 (973) 334-3100
Command Description
$Dn
DTR Dialing
$MBn
Online BPS Speed
$SBn
Serial Port Baud Rate
#CBAn
Callback Attempts
#CBDn
Callback Delay
# CBF?
Callback Failed Attempts Display
# CBFR
Callback Failed Attempts Reset
# CBIn
Local Callback Inactivity Timer
# CBNy=n
Store Callback Password
# CBPn
Callback Parity
# CBRy
Callback Security Reset
# CBSn
Callback Enable/Disable
#Pn
Set 11-bit Parity
#Sx
Enter Setup Password
#S=x
Store Setup Password
+VDR=x, y
Distinctive Ring Report
+++AT<CR>
Escape Sequence
%%%ATMTSMODEM<CR>
Remote Configuration Escape Sequence
V.92 Commands
13.2.4 “AT” Commands
Command: AT Attention Code
Values: N/A
Description: The attention code precedes all command lines except A/, A: and escape
sequences.
Command: ENTER Key
Values: N/A
Description: Press the E
NTER (RETURN) key to execute most commands.
Command: A Answer
Values: N/A
Description: Answer call before final ring.
Command: A/ Repeat Last Command
Values: N/A
Description: Repeat the last command string. Do not precede this command with AT. Do not press
E
NTER to execute.
Command: Bn Communication Standard Setting
Values: n = 0–3, 15, 16
Default: 0 and 15
Description: B0 Select ITU-T V.22 mode when modem is at 1200 bps.
B1 Select Bell 212A when modem is at 1200 bps.
B2 Deselect V.23 reverse channel (same as B3).
B3 Deselect V.23 reverse channel (same as B2).
B15 Select V.21 when the modem is at 300 bps.
B16 Select Bell 103J when the modem is at 300 bps.