4.7 GENERAL ACCESS COMMANDS
Once you have accessed the RFL 9660, you can use its general access commands to view port information,
connect your PC to a device at the substation, or run a diagnostic test. To view a list of these commands, press
the [H] and [ENTER] keys.
REMOTE> H [ENTER]
This tells the RFL 9660 to send a list of all general access commands to your PC. A typical command list
appears in Figure 4-27. The system "super-user" can display a similar list, but it has additional super-user
commands on it. (See Section 5.) Figure 4-28 shows the relationship between the general access commands.
NOTE
"Esc" and "Q" are universal commands. "Esc" will abort any command entry if it is pressed before you
press the [ENTER] key. "Q" will terminate the session; it will also move you from the configuration
modes back to the regular mode.
Esc -Abort command
H -Help
D -Run diagnostics
I -Port Information
Q -Quit session
Port #/Label -Port selection
MODEM -Connect local port to modem port
REMOTE> _
Figure 4-27. Typical general access command list display
For more information on each user operating command, refer to the page number listed below next to the
command.
Command Meaning Page
Esc Abort command 4-30
H Help 4-30
D Run diagnostics 4-30
I Port information 4-30
Q Quit session 4-32
Port #/Label Port selection 4-32
MODEM Connect local and modem ports 4-34
The "MODEM" command only appears if you are logged on as a regular user with your PC directly connected to
the RFL 9660's front-panel LOCAL connector. (See page 4-34 for more information.)
RFL 9660 RFL Electronics Inc.
April 24, 2007 4-28 (973) 334-3100
To Next Page
Loading...