RFL 9660 RFL Electronics Inc.
April 24, 2007 11-1 (973) 334-3100
Section 11. GOVERNMENT REGULATIONS
FCC (United States) As of the date of manufacture, the RFL 9660's modem is compatible with the telephone
company communications facilities with which it was intended to operate. However, if
the telephone company changes its communications facilities, equipment, operations,
or procedures such that this equipment is no longer compatible, RFL Electronics Inc. is
not responsible for the cost of modification or replacement of the modem.
Before installation, the telephone company must be notified of the intended installation.
You also must provide the telephone company with the modem FCC registration
number (AU7USA-25814-M5-E) and ringer equivalence number (0.3B). A Universal
Service Order Code (USOC) number for the RJ-11 telephone service jack must be
specified for installation by the telephone company.
The FCC does not allow the RFL 9660's modem to be connected to party lines or coin
lines.
If there are problems with the modem or you suspect a malfunction, immediately
disconnect the modem from the communications facility. Do not reconnect the modem
to the communications facility until the malfunction is corrected or you can determine
that the modem is operating properly. The telephone company can, at its option,
discontinue service to a malfunctioning modem if the modem is causing harm to the
telephone network. Once this malfunction is corrected, service can be restored.
The RFL 9660's modem can be repaired only by RFL Electronics Inc. or one of its
authorized agents.
To Next Page
Loading...