1 GIANTS 0
2 BILLS 0
3 PATRIOT 0
4 EAGLES 0
5 STEELER 0
6 BROWNS 0
7 DOLPHIN 0
8 FALCONS 0
9 LIONS 0
10 REDSKIN 0
PP 28 sec
PA 1 sec
PB 1 sec
PT 600 sec
PM 600 sec
CR \,+++\,ATZ0 0\n\,
CC BYE
CM Long CE N
CA Y CT N
CONFIG> _
Figure 5-6. Typical list of current selections for the 14.4 Kbps modem
The list of current selections shows the active states of these settings. This list does not
show the settings stored in non-volatile memory that are used as the default settings on
power-up. You should make a hard copy of the settings list each time you make changes to
these settings. The hard copy could then be used as reference if system had to be re-
configured. If you are using a PC equipped with a printer as your terminal, you can
obtain a hard copy by pressing the [PRINT SCREEN] key on your computer keyboard.
R - Reset To Factory Default
This command will reset all RFL 9660 configuration command parameters to their
original default settings. The default settings are listed on the super-user configuration
command list display in brackets, as shown below:
PP nn - Period awaiting password {5-99} [28]
To reset the RFL 9660 to its original default settings, use the "R" command.
Format:CONFIG> R [ENTER]
The following message will appear:
Are you sure? (Y/N)
RFL 9660 RFL Electronics Inc.
August 18, 1998 5-20 (973) 334-3100
To Next Page
Loading...