RFL 9660 RFL Electronics Inc.
October 1, 1999 3-7 (973) 334-3100
3.7 SETTING THE SITE ID
Before you do anything else, the "site ID" should be entered into the RFL 9660's memory. The site ID is a name
that is displayed each time the RFL 9660 is accessed. It is stored in the RFL 9660's memory as "Port 0." To set
the site ID, use the following procedure:
1. Press the [P] and [ENTER] keys.
The following prompt will appear:
Port # _
2. Press the [0] (zero) and [ENTER] keys.
The following prompt will appear:
Site ID
Old label was (old label)
Please enter new label, up to 30 characters. _
3. Type in the desired site ID. It can be up to 30 characters long, including spaces (example: "Midtown
Substation").
4. Press the [ENTER] key when you are finished entering the side ID.
The "LOCAL" prompt will reappear.
5. Save the new site ID by pressing the [S] and [ENTER] keys.
The RFL 9660 will send the following prompt to your terminal:
Are you sure? (Y/N) _
6. Answer "yes" by pressing the upper case [Y] and [ENTER] keys.
The following message will appear:
Please wait.............
Periods will be added to the line as the site ID is being stored. When storage is
complete, the "LOCAL>" prompt will reappear.
To Next Page
Loading...