RFL 9660 RFL Electronics Inc.
April 24, 2007 2-4 (973) 334-3100
To connect wires to the terminal block on the PWR/ALARM I/O (Part Number 104400) or AC/ALARM I/O (Part
Number 104400-1), you will have to remove the protective cover from the terminal block by pulling it out of the
standoffs holding it in place. After all connections have been made to the terminal block, reinstall the protective
cover by lining up its mounting holes with the standoffs on the I/O module. Once the holes and standoffs are
lined up, push down on the protective cover to secure it in place.
2.5.2 ALARM, REMOTE DISCONNECT, GROUND, AND POWER CONNECTIONS
All alarm, remote disconnect, ground, and power connections are made to the RFL 9660 through terminal block
TB1 on the PWR/ALARM I/O module. Figure 2-3 shows the connections that must be made on dc-powered
units; Figure 2-4 shows the connections for ac-powered units.
To Next Page
Loading...