RFL Electronics RFL 9660 - Section 5. CONFIGURATION COMMANDS; 5.1 INTRODUCTION; 5.2 ACCESSING THE RFL 9660 AS A SUPER-USER; 5.3 SUPER-USER COMMANDS

Section 5. CONFIGURATION COMMANDS
5.1 INTRODUCTION
In many installations, the person responsible for the RFL 9660 Digital Switch will want to control how the
RFL 9660 is configured and how users may gain access to it. This person (or some other authorized person)
would use the configuration commands in this section to control these functions. Since the people that normally
access the RFL 9660 are called "users," the person that uses the commands in this section is called the "super-
user."
The configuration commands described in this section are only available to the system super-user. You may
wish to remove this section from the users' manuals. This would help prevent unauthorized modifications to the
system configuration.
NOTE
The super-user's password is always Password #3. If you do not enable password protection,
all users will be able to use the configuration commands described in this section. Since this is
not recommended, set up and enable passwords. (See Section 3.)
5.2 ACCESSING THE RFL 9660 AS A SUPER-USER
As a super-user, you can access the RFL 9660 either locally or remotely. To access it locally, follow the
instructions in Section 3 of this manual. To access it remotely with a PC and dial-up modem, refer to Section 4.
5.3 SUPER-USER COMMANDS
Besides the general access commands described in Section 4 of this manual, the RFL 9660 has configuration
commands that can only be used when you are logged on as a super-user. To view a list of these commands,
press the [H] and [ENTER] keys. This will tell the RFL 9660 to send a list of all super-user commands to your
terminal.
A typical super-user command list appears in Figure 5-1. This is similar to the user command list shown in
Figure 4-7, but it contains more commands. Figure 5-2 on shows the relationships between all super-user
commands.
For more information on each super-user command, refer to the page number listed below. Commands on the
super-user command list that are not listed below are described in Section 4 of this manual.
Command Meaning Page
H Help 5-2
P Program port 5-2
C Configure switch 5-12
S Save changes 5-21
R Reset port parameters 5-21
U Update hardware configuration 5-22
RFL 9660 RFL Electronics Inc.
August 18, 1998 5-1 (973) 334-3100