7. Press the [ENTER] key on your keyboard a few times.
The following prompt will appear on your display:
Please enter password
When you see this prompt, enter the password on your keyboard. For each letter of the
password you enter, the RFL 9660 will echo back an asterisk (*).
NOTE
Passwords are case-sensitive. If the super-user stored the password as all capitals, you must enter
it as all capitals. Otherwise, the RFL 9660 will reject it.
8. When you finish entering the password, press the [ENTER] key.
If the RFL 9660 accepts the password, go to step 9. If it does not accept your password,
repeat steps 7 and 8.
9. Wait for the RFL 9660 to log you onto the system.
If the RFL 9660 is not using password protection, the following message will appear on
your display:
Please wait .......................(site identification message)
REMOTE> _
If the RFL 9660 is using password protection, the following message will appear on your
display:
Logged on as # (user password number)
Please wait .......................(site identification message)
REMOTE> _
Your PC is now accessing the RFL 9660. Each time you press a key on the PC's
keyboard, the RFL 9660 will respond by sending another "REMOTE>" prompt to your
PC.
If the RFL 9660 does not respond, check the connections between your PC, the modem,
and the telephone line. If they are all good, repeat the TERMINAL EMULATOR SETUP
procedure starting on pageof this manual, and then try to call up the RFL 9660 again. If
you still cannot access the RFL 9660, contact the super-user.
10. If you are receiving "REMOTE>" prompts and you would like to see a list of all the commands available
to you, press the [H] and [ENTER] keys.
A list of general access commands will appear on your display, with the "REMOTE>"
prompt beneath it. (See Figure 4-21). If you are logged on as the "super-user, the list will
also contain the configuration commands described in Section 5 of this manual.
RFL 9660 RFL Electronics Inc.
April 24, 2007 4-19 (973) 334-3100
To Next Page
Loading...