RFL 9660 RFL Electronics Inc.
August 18, 1998 6-2 (973) 334-3100
F9 Timeout on TD from DTE. This is a transient display - only for a short while.
FA Initialization failure; this is a transient display - only for a short while.
FL General diagnostic test failure.
Fo Fiber optic master (if present) being addressed.
hu Hang-up sequence (30 seconds of no DTR).
ig Port set to “ignore” (Mode 9) if no TD in 30 seconds.
no Local port connected to modem port.
PA Diagnostic test successfully completed; this is a transient display - only for a short while.
Pd Awaiting correct password entry.
PE An error was made when entering a password.
PL RFL 9660 is idle; not being accessed, but polling ports for possible connection.
rC RFL 9660 is about to reset the configuration structure.
rd Remote Disconnect activated.
ri Ring indicate pin at modem active. “PL” appears after ring.
rP RFL 9660 is about to reset the port structure.
Sr A service request has been received from a port.
td Awaiting TD from DTE (30 seconds).
to Timeout on no DTE established DCD.
u1 UART #1 has failed.
u2 UART #2 has failed.
To Next Page
Loading...