RFL Electronics RFL 9660 - Page 160

RFL 9660 RFL Electronics Inc.
April 24, 2007 13-7 (973) 334-3100
Command: P Pulse Dialing
Values:
P, T
Default:
T
Description:
Configures the modem for pulse (non-touch-tone) dialing. Dialed digits are pulsed
until a T command or dial modifier is received.
Command: Qn Result Codes Enable/Disable
Values:
n = 0 or 1
Default:
0
Description:
Q0 Enable result codes.
Q1 Disable result codes.
Q2 Returns an OK for backward compatibility with some software.
Command: Sr=n Set Register Value
Values:
r = S-register number; n varies
Default:
None
Description:
Set value of register Sr to value of n, where n is entered in decimal format (e.g.,
S0=1).
Command: Sr? Read Register Value
Values:
r = S-register number
Default:
None
Description:
Read value of register Sr and display it in 3-digit decimal form (e.g., S2? gives the
response 043).
Command: T Tone Dialing
Values:
P, T
Default:
T
Description:
Configures the modem for DTMF (touch-tone) dialing. Dialed digits are tone dialed
until a P command or dial modifier is received.
Command: Vn Result Code Format
Values:
n = 0 or 1
Default:
1
Description: V0 Displays result codes as digits (terse response).
V1 Displays result codes as words (verbose response).
Command: Wn Result Code Options
Values:
n = 0, 1, or 2
Default:
2
Description:
W0 CONNECT result code reports serial port speed, disables protocol result
codes.
W1 CONNECT result code reports serial port speed, enables protocol result
codes.
W2 CONNECT result code reports line speed, enables protocol result codes.