RFL 9660 RFL Electronics Inc.
April 24, 2007 13-9 (973) 334-3100
Command: &Fn Load Factory Settings
Values:
n = 0
Default:
None
Description
&F0 Load factory settings as active configuration.
Note: See also the Z command.
Command: &Gn V.22bis Guard Tone Control
Values:
n = 0, 1, or 2
Default:
0
Description
&G0 Disable guard tone.
&G1 Set guard tone to 550 Hz.
&G2 Set guard tone to 1800 Hz.
Note: The &G command is not used in North America.
Command: &Kn Flow Control Selection
Values:
n = 0, 3, or 4
Defaults:
3
Description
&K0 Disable flow control.
&K3 Enable CTS/RTS hardware flow control.
&K4 Enable XON/XOFF software flow control.
Command: &Ln Leased Line Operation
Values:
n = 0, 1, or 2
Defaults:
0
Description
&L0 The modem is set for standard dial-up operation.
&L1 The modem is set for leased line operation in originate mode.
&L2 The modem is set for leased line operation in answer mode.
Note: For &L1 and &L2, there is a 30-second window between power up and the
starting of the leased line handshake. During this time, you can turn off the
command, if desired.
Command: &Pn Pulse Dial Make-to-Break Ratio Selection
Values:
n = 0, 1, or 2
Default:
0
Description
&P0 60/40 make-to-break ratio
&P1 67/33 make-to-break ratio
&P2 20 pulses per second
Note: The &P2 command is available only if the country code is set to Japan.
To Next Page