RFL Electronics RFL 9660 - Page 242

RFL 9660 RFL Electronics Inc.
April 24, 2007 15-4 (973) 334-3100
U - Update hardware configuration, 5-22
Super-user, using the RFL 9660 as a, 3-24
Switch configuration commands
CA x - Enable Port Selection By Number, 5-19
CB n x... - Callback String, 5-16
CC xxx - Port Deselect Code, 5-16
CE x - Password Enable, 5-18
CM x - Message Format, 5-17
CS - Store Changes, 5-18
CT x - Enable CCITT Modem Sequence, 5-18
PA nn - Silence Before Deselect Code, 5-14
PB nn - Silence After Deselect Code, 5-14
PM nnnn - Inactive Period, Menu Mode, 5-15
PP nn - Period awaiting password, 5-14
PT nnnn - Inactive Period, Port Selected, 5-15
PW n x... - Password, 5-17
Q - Quit Programming Mode, 5-19
R - Reset To Factory Default, 5-20
S - Show Current Selections, 5-19
Switch and jumper settings, 8-1
Switch and port configuration, 3-1
Switch settings
CPU module, 8-1
fiber optic master I/O module, 9-1
fiber optic remote module, 9-3
local port, 8-2
modem module, 8-5
modem port, 8-3
System expansion, 2-13
T
Telephone connections, 2-7
Terminal blocks, making connections to, 2-2
Terminal emulator setup, 4-3
Tool, module removal, 10-6
Turning on the RFL 9660, 3-3
Typical applications, 1-10
U
Unpacking, 2-1
Updating hardware configuration, 5-22
Using the module removal tool, 10-6
Using the RFL 9660 as a super-user, 3-24
Using Microsoft Windows to load and run applications, 4-1
V
Ventilation, 2-2
Viewing a list of general access commands, 4-28
Viewing information on a specific port, 5-2
W
Windows 95 Hyperterminal setup, 4-7