If this is the first time you are using the RFL 9660 (or if passwords have not been enabled), you will be logged
on as the "super-user." If you press the [H] and [ENTER] keys, a list of super-user commands will appear. (See
Figure 3-3.) The relationships between these commands are shown in Figure 3-4.
Esc -Abort command
H -Help
D -Run diagnostics
I -Port Information
Q -Quit session
Port #/Label -Port selection
P -Program port
C -Configure switch
S -Save changes
R -Reset port parameters
U -Update hardware
MODEM -Connect Local port to Modem port.
LOCAL> _
Figure 3-3. List of super-user commands
If passwords have been set up and you did not use the super-user password, you will be logged on as a regular
user; pressing the [H] and [ENTER] keys will display a list of general access commands, as described in
Section 5. If this happens, terminate the session by pressing the [Q] and [ENTER] keys, and start another
session by pressing the [ENTER] key again. When the prompt appears asking for a password, enter the super-
user password. You cannot perform the procedures in this section unless you are logged on as a super-
user.
NOTE
"Esc" and "Q" are universal commands. "Esc" will abort any command entry if it is pressed before you
press the [ENTER] key. "Q" will terminate the session; it will also move you from the configuration
modes back to the regular mode. The "S" command saves any changes you have made to the switch
or port configuration settings. Always save your changes before you quit the session; otherwise, your
changes will be erased.
RFL 9660 RFL Electronics Inc.
October 1, 1999 3-5 (973) 334-3100
To Next Page
Loading...