RFL 9660 RFL Electronics Inc.
October 1, 1999 3-18 (973) 334-3100
3. Press the [K] and [ENTER] keys.
The following prompt will appear on your display:
Enable XON/XOFF at Modem & Local [Y]: _
This selection lets you determine whether the LOCAL and MODEM ports will use
XON/XOFF flow control when communicating with this port. As shown in the prompt,
this can be set to "Y" or "N," with "Y" being the default value.
4. Press the [Y] key to enable XON/XOFF flow control, or the [N] key to disable it. Once you have entered
your choice, press the [ENTER] key.
Only set this selection to "N" (disable XON/XOFF flow control) if the device connected
to the port uses the XON/XOFF characters for data, and not for flow control. If you are
not sure about how to set this parameter, set it to "Y" (enable XON/XOFF flow control).
If you enter an "n," the following prompt will appear on your display above the list of
selections:
Do NOT operate Modem/Local ports above 9600 baud (if the new modem is
installed)
5. Press the [J] and [ENTER] keys.
The following prompt will appear on your display:
Monitor Local port DTR {Y/N} [Y]: _
This selection lets you determine whether the DTR line will be monitored at the LOCAL
port. As shown in the prompt, this can be set to "Y" or "N," with "Y" being the default
value.
6. Press the [Y] key to enable DTR line monitoring, or the [N] key to disable it.
If you enable local port DTR monitoring, the RFL 9660 will disconnect the user if the
DTR line goes active. Set this selection to "N" (disable DTR monitoring) if the
application software for the device connected to this port toggles the DTR line during
communications sessions. Failure to do this will cause the RFL 9660 to disconnect
while you are running the application program.
7. Once you have entered your choice, press the [ENTER] key.
To Next Page
Loading...