System SP1-xxx
D086/D087 3-8 SM Appendix
Delta:End:Sp.1
011
Temp.:Lower
Delta:Press:Sp.1
*ENG
[0 to 200 / 60 / 1 deg/step]
012 Rotation Time:Sp.1 *ENG
[0 to 200 / 0 / 1 sec/step]
013
Temp.:Lower
Delta:Center:Sp.2
*ENG
[0 to 200 / 5 / 1 deg/step]
014
Temp.:Lower
Delta:End:Sp.2
*ENG
[0 to 200 / 100 / 1 deg/step]
015
Temp.:Upper
Delta:Center:Sp.2
*ENG
[0 to 200 / 15 / 1 deg/step]
016
Temp.:Upper
Delta:End:Sp.2
*ENG
[0 to 200 / 100 / 1 deg/step]
017
Temp.:Lower
Delta:Press:Sp.2
*ENG
[0 to 200 / 100 / 1 deg/step]
018 Rotation Time:Sp2 *ENG
[0 to 100 / 0 / 1 sec/step]
019 Feed Permit Time *ENG
[0 to 200 / 120 / 1 sec/step]
1105 [Print Target Temp]
(Printing Mode, Roller Type, [Color], Simplex/Duplex)
Roller Type –> Center and Ends: Heating roller, Pressure –> Pressure roller
Paper Type -> Plain, Thin, Thick, OHP, Middle Thick, Special
001
Plain1:FC:Center *ENG
[120 to 200 / 155 / 1 deg/step]
Specifies the heating roller target temperature for the ready condition in full
color printing.
002
Plain1:FC:Press *ENG
[100 to 200 / 120 / 1 deg/step]
Specifies the pressure roller target temperature for the ready condition in full
color printing..
003
Plain1:BW:Center *ENG
[120 to 200 / 145 / 1 deg/step]
Specifies the heating roller target temperature for the ready condition in BW