Scanner Unit
SM 4-13 D115/D116
Replacement
and
Adjustment
the front and back sides:
The hole in the copier's lid
The hole in the 1st scanner
The right corner hole in the 2nd scanner
The hole at the base of the scanner
6. Insert the two optics adjustment tools [A], and adjust the scanners as necessary so that the
tools go through all four holes.
7. Tighten the two screws that you loosened at step 2 above, so that the belts are firmly
clamped into place.
8. Remove the adjustment tools.
To Next Page
Loading...
