System Service Mode
SM Appendix 3-5 D115/D116
Appendix:
SP Mode
Tables
SP2-XXX (Drum)
2001*
CR Bias Adj
2001 1
Printing
[–2100 to –1500 / –1650 / 1 V/step]
Adjusts the voltage applied to the charge roller for printing. The voltage
changes automatically as charge-roller voltage control works. The value here
is the base value for the charge-roller voltage control.
2001 2
ID sensor pattern
[0 to 400 / 300 / 1 V/step]
Adjusts the voltage applied to the charge roller for the ID sensor pattern (as
part of charge-roller voltage correction). The charge-roller voltage is obtained
by adding SP2-001-002 to the value of SP2-001-001.
2101*
Erase Margin Adj
Adjusts the width of the erased area (
"Adjusting Copy Image Area" in the section
"Replacement and Adjustment").
2101 1 Leading Edge
[0.0 to 9.0 / 3.0 / 0.1 mm/step]
Specification: 2 ± 1.5 mm
2101 2
Trailing Edge
[0.0 to 9.0 / 4.0 / 0.1 mm/step]
Specification: 2 +2.5/–1.5 mm
The rear trailing edge is this value plus 1.2 mm.
2101 3
Left side
[0.0 to 9.0 / 2.0 / 0.1 mm/step]
Specification: 2 ± 1.5 mm
The rear left edge is this value plus 0.3 mm.
2101 4
Right side
[0.0 to 9.0 / 2.0 / 0.1 mm/step]
Specification: 2 +2.5/–1.5 mm
The rear right edge is this value plus 0.3 mm.
To Next Page
Loading...
