System Service Mode
D115/D116 3-82 SM Appendix
SP6-XXX (Peripherals)
6006*
ADF Adjustment (
"DF Image Adjustment" in the "Adjusting Copy Image
Area")
NOTE: Available menus depend on the machine model and its configuration.
001
StoS/Front Regist
[–5.0 to +5.0 / 0.0 / 0.1 mm/step]
Adjusts the side-to-side registration for the front side of the original, for ARDF
mode. Use the
key to select "+" or "–" before entering the value
002
Leading Regist
[–5.0 to +5.0 / 0.0 / 0.1 mm/step]
Adjusts the leading edge registration for ARDF mode. Use the key to
select "+" or "–" before entering the value.
003
Trailing Erase
[–3.0 to +3.0 / –1.5 / 0.1 mm/step]
Adjusts the trailing edge erase margin for ARDF mode. Use the key to
select "+" or "–" before entering the value.
004
S to S/ Rear Regist
[–5.0 to +5.0 / 0.0 / 0.1 mm/step]
Adjusts the side-to-side registration for the 2nd side of the original, for ARDF
mode. Use the
key to select "+" or "–" before entering the value
005
Sub-scan Magnif
[–0.9 to +0.9 / 0.0 / 0.1 %/step]
Adjusts the sub-scan magnification for the ARDF.
006
Origin Curl Adj
[0 = No / 1 = Yes]
Turns on or off the skew correction at 2nd side scanning. This SP is activated
only when the duplex mode is selected.
007
Skew Correction
[–20 to +20 / 0.0 / 1 mm/step]
Adjusts the original buckle for the skew correction at 2ns side scanning. This
SP is activated only when SP6-006-006 is set to "1 (Yes)".
To Next Page
Loading...
