Ricoh Aficio MP201SPF Service Manual

BICU and Controller Board
SM 4-39 D115/D116
Replacement
and
Adjustment
When installing a new controller board
1. Install the NVRAM from the old controller board on a new controller board.
1. Install the new controller board in the machine.
2. Disconnect the cables of the HDD from the controller board if the HDD option has already
been installed.
 Disconnecting the cables of the HDD is very important. Otherwise, the HDD is
automatically formatted and all data in the HDD is lost due to the security limitation.
3. Reassemble the machine.
4. Turn on the main power of the machine.
 If the HDD option has not been installed, the installation procedure is completed.
 If the HDD option has already been installed, go to next step.
5. Turn off the main power of the machine, and then connect the cables of the HDD again.
 Make sure you print out the SMC reports ("SP Mode Data" and "Logging Data") before
you replace the NVRAM.
 Keep NVRAMs away from any objects that can cause static electricity. Static electricity
can damage NVRAM data.
 Make sure the NVRAM is correctly installed on the controller board.

Ricoh Aficio MP201SPF Specifications

General

Type	Multifunction Printer
Functions	Print, Copy, Scan, Fax
Print Technology	Laser
Max Print Resolution	600 x 600 dpi
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Fax Transmission Speed	3 seconds per page
Modem Speed	33.6 Kbps
Standard Paper Capacity	250 sheets
Connectivity	USB 2.0, Ethernet
Dimensions	485 x 450 x 481 mm
Warm-up Time	30 seconds
Paper Output Capacity	100 sheets
Print Speed	20 ppm
Copy Speed	20 cpm
Scanner Type	Flatbed
Zoom	25% - 400%
Supported Paper Sizes	A4, A5, A6, B5, Legal, Letter
Operating System Compatibility	Windows, Mac, Linux
Duplex Printing	Automatic