Card Save Function
SM 6-39 D115/D116
Trouble-
shooting
13. Use the arrow key and select “Cardsave (ADD) or Cardsave (New).
14. To enable the newly configured settings, select “switch” button and then press the “Return”
button to exit the “List/Test Print” menu.
15. Send a job to the printer.
16. As soon as the printer receives the data, it will be stored on the SD card automatically with
no print output. Nothing is displayed on the screen indicating that a Card Save operation
was successful.
17. Press the “Return” button to exit Card Save mode.
18. Change the Bit Switch Settings back to the default 00000000.
19. Remove the SD card after main power switch is turned off.
Error Messages
Card Save error messages:
Init error: A card save process (i.e. card detection, change to kernel mode) failed to
initialize.
Card not found: Card cannot be detected in the slot.
No memory: Insufficient working memory to process the job.
Write error: Failed to write to the card.
Other error: An unknown error occurred.
If an error occurs, pressing “OK” will cause the device to discard the job and return to the ready
state.
To Next Page
Loading...
