Ricoh Aficio MP201SPF - Conducting Input Check; Input Check (Sp5-803); Input Check Table

System Service Mode
SM Appendix 3-117 D115/D116
Appendix:
SP Mode
Tables
3.1.2 INPUT CHECK (SP5-803)
Conducting Input Check
1. Select SP5-803.
2. Select the number (see the table below) corresponding to the component.
3. Select "Execute." The copy mode is activated.
4. The sign "01H" or "00H" is displayed (see the table below).
Input Check Table
Num. Sensor/Switch 1h 0h
001 Safety SW Open Closed
003 Right Cover SW Open Closed
006 Upper Relay S Paper detected Not detected
007 Lower Relay S Paper detected Not detected
009 Regist Sensor Paper detected Not detected
010 Exit Sensor Paper detected Not detected
011 Duplex Inverter S Paper detected Not detected
014 By-pass PE S Paper detected Not detected
016 Upper PE S Paper detected Not detected
017 BK-Upper PE S Paper detected Not detected
020 BK-Lower PE S Paper detected Not detected
027 PCU Set Signal Installed Not installed
028 BK type * *
030 Duplex Installed Installed Not installed
032 Main M Lock Locked Not locked
033 Polygon M Lock Locked Not locked