System Service Mode
D115/D116 3-26 SM Appendix
12: Exp. Key card (Deduct)
002 Opt Cnt Type 2 CTL
This program specifies the external counter
type.
0: None
1: Expansion Device type 1
2: Expansion Device type 2
3: Expansion Device type 3
5114
Optional Counter I/F CTL
[0: Not installed/ 1: Installed (scanning
accounting)]
001 MF Key Card Ext. Japan use
5118
Disable Copying CTL
[0: Not disabled/ 1: Disabled]
001 This program disables copying.
5120*
Clr For Cut Remove
[0=Yes / 1=Standby only / 2=No]
5120 1
Specifies the condition to reset the copy job settings when the key counter is
removed.
0: Y = Yes: The settings are cleared when the counter is removed.
1: StdBy = Standby only: The settings are cleared when the counter is
removed at the end of a job.
2: N = No: The settings are not cleared under either condition.
As for duplex copying, the job settings are always preserved regardless of
these setting.
5121*
Counter Up Timing
[0 = Feed In / 1 = Exit]
5121 1
Selects the count-up timing.
0 = Feed: At each paper feed
1= Exit: At each paper exit
To Next Page
Loading...
