Problem Cause Solution
Misfeeds occur frequently. There is a foreign object on
the output tray.
• Remove the misfed paper. For
details about removing jammed
paper, see page 495 "Removing
Jammed Paper".
• Do not place anything on the
output tray.
Misfeeds occur frequently. The staple cartridge is not
set correctly.
Set the staple cartridge properly. For
details about how to add staples, see
page 526 "Adding staples".
Misfeeds occur when
printing to envelopes.
The envelopes are curled. Make sure you fully flatten curled
envelopes before you load them. Do
not stack envelopes over the specified
limit for the paper tray. If misfeeds still
occur after the envelopes have been
flattened, load envelopes on the tray
one at a time and print them
individually. For details about how to
load envelopes, see page 235
"Envelopes".
When printing to envelopes,
the envelopes may be fed in
together, or the envelopes
may not be fed.
The envelopes are curled. Make sure you fully flatten curled
envelopes before you load them. Do
not stack envelopes over the specified
limit for the paper tray. If misfeeds still
occur after the envelopes have been
flattened, load envelopes on the tray
one at a time and print them
individually. For details about how to
load envelopes, see page 235
"Envelopes".
Cannot print in duplex
mode.
You have selected a paper
tray that is not set for duplex
printing.
Change the setting for "Apply Duplex"
in "Tray Paper Settings" to enable
duplex printing for the paper tray. For
details about setting "Apply Duplex",
see page 243 "Tray Paper Settings".
Getting Started
419
To Next Page
Loading...
