Problem Cause Solution
The function does not run or
cannot be used.
If you cannot carry out your
job, it may be that the
machine is being used by
another function.
Wait until the current job is completed
before trying again.
For details about Function
Compatibility, see page 423
"Function compatibility".
Output paper to the stacker
tray does not align properly.
• Paper is curled.
• When using coated
paper, the output
paper to the stacker
tray might fail to align
properly.
• When the paper is curled
downward, select [ Curl
Correction Level: Small] or [
Curl Correction Level: Large]
under [Correct Output Paper
Curl] in "Adjustment Settings for
Operators".
• When the paper is curled
upward, select [ Curl Correction
Level: Small] or [ Curl
Correction Level: Large] under
[Correct Output Paper Curl] in
"Adjustment Settings for
Operators".
For details about the Adjustment
Settings for Operators, see page 271
"Adjustment Settings for Operators".
Output paper to the stacker
tray does not align properly.
When the paper weight is
280.0 g/m
2
or more, and
the paper size is A3, SRA3
or larger, the output paper
to the stacker tray might fail
to align properly.
Select [ Curl Correction Level: Small]
or [ Curl Correction Level: Large]
under [Correct Output Paper Curl] in
"Adjustment Settings for Operators".
For details about the Adjustment
Settings for Operators, see page 271
"Adjustment Settings for Operators".
Getting Started
421
To Next Page
Loading...
