To Next PageTo Next PageHow to fix '-2202 Cannot locate device' error on Ricoh Gateway?
If you see the message '-2202 Cannot locate device' on your Ricoh Gateway, the OA I/F (RS-485) cable might not be connected. Ensure that the OA I/F (RS-485) cable is properly connected.
What to do if Ricoh Remote Communication Gate Gateway shows '-2320 Cannot register device'?
If the Ricoh Gateway displays '-2320 Cannot register device,' it may be because you've exceeded the maximum number of devices allowed. Each RC Gate can register up to 100 devices.
Explains the two communication methods: E-mail (SMTP) and Internet encryption (HTTPS).
Highlights important symbols and safety precautions during operation.
Outlines environmental requirements and precautions for setting up the equipment.
Provides step-by-step instructions for connecting the power cable securely.
Details how to connect the telephone line for the BM1 model.
Guides users on how to change the LAN2 port IP address if needed.
Provides instructions for connecting the network interface cable.
Lists the necessary hardware and software for using the RC Gate Monitor.
Provides steps to launch and exit the RC Gate Monitor application.
Guides through registering the equipment using the SMTP email method.
Guides through registering the equipment using the HTTPS method.
Outlines the process for setting up automatic device discovery.
Detailed steps to configure and run the Auto Discovery wizard.
Step-by-step guide to registering image I/O devices.
Instructions for updating device firmware from a server.
Instructions for changing the RC Gate Monitor login password.
Provides solutions for common error messages and issues.
General