6. Place the original on the exposure glass with the back side faced down and with the
top to the rear of the machine, and then press [Start].
When using the four-line LCD panel model
1. Press the [Shortcut to Func.] key.
To make the [Shortcut to Func.] key enable ID card copy mode for the current job, [Shortcut to
Function] under [Admin. Tools] must be set to [ID Card Copy Mode]. You can also assign the
setting using Web Image Monitor.
For [Shortcut to Function], see page 310 "Administrator Tools Settings (When Using the Four-
line LCD Panel Model)".
2. To make multiple copies, enter the number of copies using the number keys.
3. Place the original with the front side faced down in the upper-left corner of the
exposure glass.
4. Press the [Start] key.
A message prompting you to place the original back side down on the exposure glass
appears on the display.
5. Place the original on the exposure glass with the back side faced down and with the
top to the rear of the machine, and then press the [Start] key again.
Copying an ID Card
133
To Next Page
Loading...
