Ricoh SP 3710SF - Page 136

• Depending on the thickness of the card, shadows may appear around the edges of the copy of the
card.
• For the ID card copy function, you can set the machine to print a line in the middle of the printed
paper. Specify [Center Line] in [ID Card Setting] under [Copier Features] if you are using the touch
panel model, or specify [ID Card Center Line] in [ID Card Settings] under [Copier Features] if you
are using the four-line LCD panel model.
• You can change the scanning size for the ID card function. Specify [Card Size] in [ID Card Setting]
under [Copier Features] if you are using the touch panel model, or specify [ID Card Size] in [ID
Card Settings] under [Copier Features] if you are using the four-line LCD panel model.
• After you load the originals, press the [Start] key within the time specified in [System Reset Timer] or
[System Auto Reset Timer]. Otherwise, the job is canceled. For details, see page 271
"Administrator Tools Settings (When Using the Touch Panel Model)" or page 310 "Administrator
Tools Settings (When Using the Four-line LCD Panel Model)".
• Regardless of the machine's reduction or enlargement ratio setting, an ID card copy will always be
made at 100%.
• Temporary job settings are cleared in the following cases:
• When no input is received for the period of time specified in [System Reset Timer] or [System
Auto Reset Timer] while the initial screen is displayed. For details, see page 271
"Administrator Tools Settings (When Using the Touch Panel Model)" or page 310
"Administrator Tools Settings (When Using the Four-line LCD Panel Model)".
• When the [Clear/Stop] key is pressed while the initial screen is displayed.
• When the machine's mode is changed.
• When the power is turned off.
• When the machine's default for the same setting is changed.
4. Copying Originals
134