Ricoh SP 3710SF - Page 394

Message Causes Solutions
Cannot copy.
Set original to ADF.
Combined copying could not be
performed because the originals
were not placed in the ADF.
• Use the ADF, even when copying a
single sheet.
• When Using the Touch Panel Model
If you need to use the exposure glass,
select [Off] or [Manual 2Sd Scan
Mode] in [Duplex/Combine] under
[Copier Features], and then try again.
See page 239 "Copier Features
Settings (When Using the Touch
Panel Model)".
• When Using the Four-line LCD Panel
Model
If you need to use the exposure glass,
select [Off] or [Manual 2Sdd Scan
Mode] in [Duplex/Combine] under
[Copier Features], and then try again.
See page 287 "Copier Features
Settings (When Using the Four-line
LCD Panel Model)".
Check Paper Size The paper size set for the
document differs from the size of
the paper in the indicated tray.
• When Using the Touch Panel Model
Press [Form Feed] to begin printing,
or press [Job Reset] to cancel the job.
• When Using the Four-line LCD Panel
Model
Press the [OK] key to begin printing,
or press the [Back] key to cancel the
job.
Check Paper Type The paper type set for the
document differs from the type
of the paper in the indicated
tray.
• When Using the Touch Panel Model
Press [Form Feed] to begin printing,
or press [Job Reset] to cancel the job.
• When Using the Four-line LCD Panel
Model
Press the [OK] key to begin printing,
or press the [Back] key to cancel the
job.
10. Troubleshooting
392