Specifying Scan Settings for Copying
This section describes how to specify image density and scan quality for the current job.
Adjusting Image Density
There are five image density levels. The higher the density level, the darker the printout.
1. Press the [Home] key.
2. Press the [Copier] icon on the [Home] screen.
3. Press [Text/Photo].
4. Press [ ] or [ ] to select the desired density level, and then press [OK].
• You can change the machine's default [Density] setting to always make copies with a specific
density level. For details, see page 223 "Copier Features Settings".
• Temporary job settings are cleared in the following cases:
• When no input is received for the period of time specified in [System Reset Timer] while the
initial screen is displayed. For details, see page 257 "Administrator Tools Settings".
• When the [Clear/Stop] key is pressed while the initial screen is displayed.
• When the machine's mode is changed.
• When the power is turned off.
• When the machine's default for the same setting is changed.
Selecting the Document Type According to Original
There are three document types:
4. Copying Originals
124
To Next Page
Loading...
