EasyManua.ls Logo

Ricoh SP C260SFNw - Specifying Resolution

Ricoh SP C260SFNw
444 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7. Press [ ] or [ ] to select the desired density level, and then press [OK].
You can change the machine's default [Density] setting to always scan with a specific density level.
For details, see page 228 "Scanner Features Settings".
Temporary job settings are cleared in the following cases:
When no input is received for the period of time specified in [System Reset Timer] while the
initial screen is displayed. For details, see page 257 "Administrator Tools Settings".
When the [Clear/Stop] key is pressed while the initial screen is displayed.
When the machine's mode is changed.
When the power is turned off.
When the machine's default for the same setting is changed.
Specifying Resolution
This section describes how to specify the scan resolution for the current job.
There are six resolution settings. The higher the resolution, the higher the quality but greater the file size.
1. Press the [Home] key.
DUE302
2. Press the [Scanner] icon on the [Home] screen.
3. Select the desired destination tab.
4. Press [Address Book].
5. Select the desired destination, and then press [OK].
6. Press [Scan Setting].
7. Press [Resolution...].
8. Select the desired resolution, and then press [OK].
9. Confirm the resolution you selected is displayed, and then press [OK].
5. Scanning Originals
174

Table of Contents

Other manuals for Ricoh SP C260SFNw

Related product manuals