3. Confirm the value after modification: press OK key.
Note:
When xLogic is running, not only time value but also time unit(S,M,H) can be
altered , but Besides alter time parameter at RUN time ,you can alter time
base(s=second, m=minute ,h=hour).
Current value of time T
View time T in parameter mode:
You are allowed to modify configuration time. Switch on/off time for a time segment.
In parameter mode, time segment figure of a timer:
You can alter the time and date of switch on/off.
Current value of counter
In parameter mode, the parameter view of a counter:
To Next Page
Loading...
