To Next Page

To Previous Page

13.1.1 Instrument Settings

Press > System > Instrument Settings or tap > Utility > System >

Instrument Settings to access the interface as shown in the figure below. The

Instrument Settings interface allows you to configure the front-panel Preset key,

beeper, and power-on settings.

Figure 13.2 Instrument Settings Interface

Beeper

Tap Beeper switch to toggle between ON and OFF to enable or disable the beeper

sound. When it is turned on, the click heard is enabled when the touch screen is used

or the front-panel keys and knob are used.

Power-on Setting

You can tap the

Power On drop-down button to select the state that will be loaded at

power-up. This can be either “Default” or “Last”. The default setting is "Default”.

• Default: Uses the factory setting, except for the parameters that are not affected

by factory reset.

• Last: Loads the system state at the last power-off.

Preset Key Function

Tap

Preset to define the function of the front-panel “Preset” key. You can select

“Default”. Press on the front panel and a prompt message “Restore the

instrument to factory default settings?” is displayed. Tap Yes to restore to factory

default.

Utility

DP2000 User Guide

Rigol DP2000 Series User Manual

Other manuals for Rigol DP2000 Series