13.1.2 Display Options
Press > System > Display Options or tap > Utility > System > Display
Options to enter the interface as shown in the figure below.
Figure 13.3 Display Options Interface
Language
The series power supply supports multiple languages. You can tap the Language
drop-down button to select the system language.
Brightness
Use the slider of
Brightness to adjust the brightness of the display. The range is from
1% to 100%, and the default is 50%. This setting is non-volatile; it will not be changed
by factory reset.
13.1.3 Sense Settings
When the power supply outputs high range current, the voltage drop in the load
leads cannot be ignored. To ensure correct voltage drop for the load, this series
power supply provides the Sense (remote sensing) working mode for rear output
terminals. This mode makes the voltage at the load identical to your voltage settings
by monitoring the voltage at the load rather than at the output terminal which
automatically compensates for the voltage drop in the load leads.
The following figures illustrate load connections using 2-wire sensing and remote
sensing.
Utility
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
DP2000 User Guide
67
To Next Page
Loading...
Need help?
General
