ROBOTIQ Wrist Camera - LED Status Indicators

Wrist Camera Instruction Manual
10.1. LED status
LED status Description Solutions
Off The Camera is not powered. Check the Camera's power supply and electrical setup
(please refer to the Electrical Setup section).
Solid red No fault but the Camera is not
communicating.
Start or do a stop/start cycle of the Vision server.
To do so, go in the Installation tab, choose Camera and
then the Camera tab.
Click on Start camera to start the Vision server.
The output image will appear and the LED will turn blue.
Check the USB cable connection and the software
package versions.
Solid blue and red at
the same time
The Camera is in fault or
booting.
Wait for the booting process to be completed.
If the LED stays solid blue and red, disconnect the
Camera's USB cable and power cycle it.
The red LED should be solid red. Reconnect the USB
cable.
The LED should turn solid blue when communication is
established with the Vision server
(click on Start camera from the Installation tab).
Blinking blue and red Major fault:
l Camera's input voltage is
notsufficient
l Temperature is greater
than70°C
l Check the power supply to make sure it is 24 V DC
+/- 10%.
l The Wrist Camera should not operate at a
temperature higher than 50°C.
Solid blue Not fault and communicating. -
©Robotiq inc. 2016-2018
104