Wrist Camera Instruction Manual
6.3. Edit Detection Threshold and Object Location
It is possible to edit both the detection threshold and the object location after the Teach object wizard has been
completed. To do so, select the Cam Locate node, go to the Command tab and tap Test/Modify.
l To modify the saved object position, place the object in the desired position. Test is with the Test locating object
button and, when in the desired position, tap Define new position. The position is saved. Tap Save & close to exit the
wizard. This also saves the threshold.
l To modify only the detection threshold, modify it and test it. Once it is at the required value, tap Save & close. This
does not modify the object position previously saved.
l To modify both the threshold and the object location, adjust the threshold, place the object in the desired position
and test is with the Test locating object button. Once in the desired position, tap Define new position. The position is
saved. Tap Save & close to save the threshold.
©Robotiq inc. 2016-2018
89
To Next Page
Loading...
