ROBOTIQ Wrist Camera

To Next Page

To Previous Page

Wrist Camera Instruction Manual

Along with your kit you will have the calibration board used for UR3 robots on one side the the board, part number

ACC-CALIB-BOARD. The color balance circles are not used yet with the vision system and are for future use. If you loose or

damage your board, you can print the following file:

Info

UR3 calibration board must be printed on Letter (8.5'' x 11'') or A4 paper, make sure scale is at 100%. You can

validate that your calibration board had the good scale by measuring the scale on your sheet.

ROBOTIQ Wrist Camera - Page 32