Roche Cedex Bio - Page 555

Roche Diagnostics
Operator’s Manual · Version 3.4 G-21
Cedex Bio analyzer Index
selecting groups of list items
–See, filtering.
selecting, tests to be calibrated, B–68
sensors, ISE, F–11
sequence of processing, B–155
service representative, contacting, D–25
setting up, order definition, B–40
sheets, barcodes, B–98
shift
– finishing, B–84
– starting, B–11
short guides
– analyzing samples, B–38
–calibration, B–66
– End of Shift, B–85
– ISE Prepare phase, F–22
– Prepare phase, B–14
–QC, B–75
shutting down the system
– end of shift, B–96
– stop option, A–125
slope calculation, C–33
slope out of range check, C–33
software
– importing, B–123
– updating, B–123
software data handling, specifications, A–66
Sol 1 factor, C–32
Sol 1 factor check, C–34
solutions, ISE, F–8
special characters, A–77
specifications, technical, A–65
spillages, safety, A–9
standby, ISE status, F–12
starting
– a run, B–48
– processing, B–48
– shift, B–11
STAT orders, B–45
status
– analyzer, B–52
– cuvettes, B–31
– ISE unit, F–73
– reagent sets, B–25
–sample tubes, B–49
– standby for ISE, F–12
– system, A–36
stop, screen, A–125
stopping
– printing, A–80, B–64
– processing, B–55
– run, B–55
storage facilities, specifications, A–66
switching
– between upper and lower-case, A–76
– off, B–96
– on, B–11
symbols, –8
syringe
– assembly, A–46
– hardware, A–46
system
– definitions, B–180
– logging on, B–12
–preparing, B–13
– preparing ISE, F–22
– See also, analyzer.
system status
– overview, A–36
– screen, A–98
systems
–fluid, A–45
– See also, units, assemblies.
T
tabs, B–129
– assigning tests, B–129
– Overview, A–86
– removing tests, B–130
– Utilities, A–112
– Workplace, A–100
technical specifications, A–65
test panels
– assigning tests, B–129
test range check, C–16
test selection, screen, A–91
test status, screen, A–92
tests
– adding to profile, B–158
– assigning to tabs, B–129
– defining profiles, B–158
– performing, B–37
– removing from profile, B–159
– removing from tabs, B–130
– repeating, B–61
– rerunning, B–62
text, typing, A–75
third-party software, A–8
throughput, specifications, A–65
touchscreen
– adjusting, B–140
– test mode, A–128
trademarks, 2
transfer head, A–48
transfer unit, A–48
transmission, checking of results, B–89
transport, safety, A–5