Rockwell Automation Allen-Bradley IMPACT 1336 Series

1–5Control Logic Wiring and Adapters
Publication 1336 IMPACT-6.8 – November, 2002
Figure 1.3
L Option Mode Selection and Typical TB3 Connections
Precharge Enable
19
20
21
22
23
24
25
26
27
28
29
30
Status
Common
Status
Status
Status
Common
Status
Status
Status
Common
Factory Default
19
20
21
22
23
24
25
26
27
28
29
30
Common
Common
Common
Jog Stop
Accel
Digital
Pot Up
Jog
Speed Speed 2nd/1st
Decel
Digital
Pot Dn
Local
23456
Mode
Drive must be stopped to take Local Control.
Control by all other adapters is disabled (except Stop).
2
These inputs must be present before drive will start. 3
User ConnectionsUser Connections
Momentary
Maintained
Enable
3
Enable
3
Not Stop
6
, Clear Fault
3,5
Speed Select 2
1
Speed Select 1
1
Select 3
1
Select 3
1
Control
2
Single-Source, Three-Wire Control
L Option Mode (parameter 116) = 2 – 6, 17, 18, and 27
L Option Mode (parameter 116) = 1
Not Stop
6
, Clear Fault
3,5
Rev/Fwd
4
17 18
Proc
Trim
Flux En
ResetRamp
4 Bit 11 of Logic Options (parameter 17) must be 0 for reverse direction control.
5
For soft faults only. You need to recycle power to the drive or reset to clear.
For hard faults, refer to Chapter 2, Troubleshooting and Error Codes.
6
To configure the stop type, refer to Logic Options (parameter 17).
7
8
Latched starts require a stop to stop the drive.
In mode 5, the MOP value is not reset to 0 when you stop. In mode 27,
the MOP value is reset when you stop.
Available in versions 2.02 and later.
Start
7
8
27
8,9
Digital 2nd/1st
Type
6
Pot Up
Digital
Pot Dn
9
Refer to Table 1.B. 1