Specifications and Site Requirements
Mechanical Specifications
QuickStick HT User Manual 125
Rockwell Automation Publication MMI-UM007F-EN-P - September 2020
1/2 Meter Motor
Figure 4-2: 1/2 Meter Motor Mechanical Drawing
NOTE: QuickStick HT motors have an external motor drive (see Figure 4-5 and Figure 4-7).
The exclusion zones that are shown are for the QSHT motor only. Additional exclu-
sion zones may be required based on the design of the vehicle and the material being
transported.
Ingress Protection Rating: IP67 (IP68 optional).
See Motors (Stators) on page 133 for the electrical specifications.
Contact ICT Customer Support for current detail drawings.
Exposed Materials
• 302, 304 Stainless Steel.
• 300 Series Corrosion Resistant Steel.
• Aluminum alloy with chromate over cadmium plating.
• Nickel plated brass.
• Nitrile.
• Neoprene.
All Dimensions in Millimeters [Inches]Weight: 19.5 kg [43.0 lb]
CABLE DIRECTION
FORWARD DIRECTION OF TRAVEL
CABLE DIRECTION
UPSTREAM
DOWNSTREAM
488 ±0.5
[19.2 ±0.02]
42
[1.7]
78
[3.1]
2X CLEARANCE FOR DRIVE & SENSE
RIGHT ANGLE CABLE CONNECTOR
73.0 ±0.7
[2.87 ±0.03]
104 ±1
[4.1 ±0.04]
91
[3.6]
0
115.0
[4.53]
115.0
[4.53]
155.0
[6.10]
155.0
[6.10]
200.0
[7.87]
50.0
[1.97]
230.5
[9.07]
C
L
SENSE CONNECTOR
DRIVE CONNECTOR
(FOR CUSTOMER PROVIDED
ALIGNMENT PIN)
8X M6X1.0 - 6H
8
GND HOLE
M6X1.0 - 6H
8.0
MAX ALLOWABLE TORQUE = 4.8 Nm (42 IN-LBS)
0
35.3
[1.39]
35.00
[1.378]
35.00
[1.378]
31.5
[1.24]
C
L
(SENSE CONN)
(DRIVE CONN)
5.05±0.05 6.0
ALIGNMENT SLOT
To Next Page
Loading...
