Rockwell Automation MagneMotion QuickStick HT User Manual

Changes
QuickStick HT User Manual 21
Rockwell Automation Publication MMI-UM007F-EN-P - September 2020
•In Chapter 6, Operation, added a description of Block Release to the Theory of Opera-
tion. Added information about Power-Related Warnings and Faults when using QSMC
Motor Controllers and the Soft Start circuit.
• Added the Back Cover.
Updated the following:
• The revision from alpha (Rev. D) to numeric (Ver. 04).
• Trademark and copyright information.
• The graphic used for pinch/crush hazards.
• The structure of these changes descriptions.
•In Chapter 1, Introduction, updated the Transport System Software Overview.
•In Chapter 2, Safety Guidelines, updated the Recycling and Disposal Information.
•In Chapter 4, Specifications and Site Requirements, updated the RS-422 Cable Pinouts
description. Updated the Site Requirements to identify each component.
•In Chapter 6, Operation, updated the Simulated Operation Differences to identify
functions that are not simulated.
•In Chapter 8, Maintenance, updated the Power-Related Troubleshooting and Light
Stack Troubleshooting.
•In the Appendix, updated the Transport System Limits.
• Updated the Glossary.
Rev. E
Added the following:
• Added information about the NC-E and NC-S node controllers.
• Added information on the QSHT double-wide motor.
•In Chapter 1, Introduction, added description of the NC-E node controller. Added
descriptions of Restricted Parameter files and MICS files.
•In Chapter 2, Safety Guidelines, added the Loose Material Hazard caution.
•In Chapter 3, Design Guidelines, added information about mounting two magnet
arrays end-to-end to Magnet Array Length and Attractive Force on page 103.
•In Chapter 6, Operation, added a description of Block Ownership. Added power man-
agement and fault information. Added an overview of the node controllers. Detailed
information is in the Node Controller Hardware User Manual, MMI-UM013.
Updated the following:
• The revision from numeric (Ver. 05) to alpha (Rev. E).
• Changed all Customer Support references from MagneMotion to ICT.

Rockwell Automation MagneMotion QuickStick HT Specifications

General

Brand	Rockwell Automation
Model	MagneMotion QuickStick HT
Category	Accessories
Language	English