Specifications and Site Requirements
Mechanical Specifications
126 MagneMotion
Rockwell Automation Publication MMI-UM007F-EN-P - September 2020
1/2 Meter Double-wide Motor
Figure 4-3: 1/2 Meter Double-wide Motor Mechanical Drawing
NOTE: QuickStick HT motors have an external motor drive (see Figure 4-5 and Figure 4-7).
The exclusion zones that are shown are for the QSHT motor only. Additional exclu-
sion zones may be required based on the design of the vehicle and the material being
transported.
Ingress Protection Rating: IP67 (IP68 optional).
See Motors (Stators) on page 133 for the electrical specifications.
Contact ICT Customer Support for current detail drawings.
Exposed Materials
• 302, 304 Stainless Steel.
• 300 Series Corrosion Resistant Steel.
• Aluminum alloy with chromate over cadmium plating.
• Nickel plated brass.
• Nitrile.
• Neoprene.
All Dimensions in Millimeters [Inches]Weight: 34.0 kg [74.9 lb] Est
GND HOLE
M6X1.0 - 6H
8.0
CABLE DIRECTION
CABLE DIRECTION
ALIGNMENT SLOT
(FOR CUSTOMER PROVIDED ALIGNMENT PIN)
12X M6X1.0 - 6H
8
MAX ALLOWABLE TORQUE = 4.8 Nm (42 IN-LBS)
5.05±0.05 6.0
C
L
0
C
L
115.0
[4.53]
115.0
[4.53]
155.0
[6.10]
155.0
[6.10]
192.5
[7.58]
0
200.0
[7.87]
50.0
[1.97]
SENSE CONNECTOR
DRIVE CONNECTOR
42
[1.7]
78
[3.1]
2X CLEARANCE FOR DRIVE & SENSE
RIGHT ANGLE CABLE CONNECTOR
73.0 ±0.7
[2.87 ±0.03]
178 ±1
[7.0 ±0.04]
60.00
[2.362]
60.0
[2.362]
91
[3.6]
488.2 ±0.5
[19.2 ±0.02]
FORWARD DIRECTION OF TRAVEL
UPSTREAM
DOWNSTREAM
To Next Page
Loading...
