Basic Instrument Functions
R&S
®
CMW500
103User Manual 1173.9463.02 ─ 06
Network Segment ← Subnet Node
Selects the network segment to be used for the subnet. The subnet mask always equals
255.255.0.0.
The first two IP address octets depend on the selected network segment:
●
A: 172.22.y.z
●
B: 172.18.y.z
Remote command:
CONFigure:BASE:IPSet:SNODe
SENSe:BASE:IPSet:SNODe:NSEGment?
Confirm ← Subnet Node
Applies or cancels changes of the subnet node configuration.
Applying a changed "Node ID" or "Network Segment" initiates a reboot of the instrument.
Remote command:
CONFigure:BASE:IPSet:SNODe
Network Adapter
Allows to assign a subnet conform IP address to the "Lan Remote" network adapter of
the instrument.
To do so, enable the checkbox and press the "Apply" button.
As a consequence, DHCP is disabled, any IP addresses already assigned to the "Lan
Remote" network adapter are removed and the displayed fixed IP address is assigned
instead.
The displayed state indicates whether the displayed address has been successfully
assigned to the network adapter ("Status Adjust") or not ("Status Not Adjust").
Remote command:
CONFigure:BASE:IPSet:NWADapter<n>
Subnet Monitor
List of all nodes detected in the subnet, including the instrument itself. The list indicates
the name, the type, the ID and the description of each node. For the R&S CMW500 this
information corresponds to the values in section "Subnet Node" on page 102.
Detected subnet nodes can for example be other R&S CMW500 (Type = CMW) or exter-
nal PCs (Type = PC).
Press the "Refresh" button to initiate a new scan of the subnet.
The subnet monitor is especially useful for troubleshooting. When you have connected
a network node to the internal subnet, check whether it is detected and whether there are
address conflicts (same ID used by several nodes).
Remote command:
SENSe:BASE:IPSet:SMONitor:NAME?
SENSe:BASE:IPSet:SMONitor:TYPE?
SENSe:BASE:IPSet:SMONitor:ID?
SENSe:BASE:IPSet:SMONitor:DESCription?
SYSTem:BASE:IPSet:SMONitor:REFResh
Setup Dialog
To Next Page
Loading...
