Getting Started
R&S
®
Scope Rider RTH
14User Manual 1326.1578.02 ─ 12
1. Turn off the instrument power. Remove power supply, probes, test leads and all
other cables.
2. Fold out the tilt stand on the back of the instrument.
3. Screw open the battery cover.
4. Insert the battery pack.
5. Screw down the battery cover.
6. Connect the power adapter to the connector on the left side of the scope, and fully
charge the battery. Charging may take a few hours.
Preparing for Use
To Next Page
Loading...
