Waveform Setup
R&S
®
Scope Rider RTH
40User Manual 1326.1578.02 ─ 12
5. Switch off the test circuit.
6. Connect the probe to the DUT.
7. Switch on the test circuit.
3.2 Vertical Setup
The controls and parameters of the vertical system adjust the scale and position of the
waveform vertically.
1. To set vertical scale and position, use the [RANGE] and [POS] keys.
2. To adjust other vertical settings, select "Vertical" in the main menu.
Vertical scale and vertical position affect the resolution of the waveform amplitude
directly. To get the full resolution, make sure that the waveforms cover most of the
screen's height.
Vertical Setup
To Next Page
Loading...
